2. Insert the ignition key into the ignition lock cylinder - do not turn ignition switch.
3. Press and hold the DOOR unlock switch (This is the switch on the door, NOT the remote).
4. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF, ON, OFF.
5. Release the DOOR unlock switch. The doors will lock and unlock one time to confirm the program mode is actuvates.
6. Simultaneously press and hold the LOCK button and the UNLOCK button on one keyless remote for approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to four transmitters.
8. Turn the ignition switch to the ON (one more click forward) position in order to exit the keyless entry transmitter mode.
9. Operate the transmitter functions in order to verify correct system operation.
10. [edit] Warnings Some models may require security system or other fuses to be removed.
[edit] Tips
* On some models, the first keyless entry programmed will set to Driver 1, and the second to Driver 2.
1. Access the programming connector located in the LH trunk. Trim may have to be pulled back to access programming connector.(Connector has wires leading up to it and it is not connected to anything.)
2. Jump programming connector terminals.
3. System should now lock and unlock doors to indicate programming
mode has been entered.
4. Press any button on keyless remote once.
System should now lock and unlock doors, indicating
successful programming of keyless remote.
5. Repeat step 4 for additional remote or other existing keyless remote.
NOTE: A maximum of only two Keyless Remotes can be programmed.
6. Remove programming connector jumper wire to exit programming mode.
Comments
1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder - do not turn ignition switch.
3. Press and hold the DOOR unlock switch (This is the switch on the door, NOT the remote).
4. While holding the DOOR lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF, ON, OFF.
5. Release the DOOR unlock switch. The doors will lock and unlock one time to confirm the program mode is actuvates.
6. Simultaneously press and hold the LOCK button and the UNLOCK button on one keyless remote for approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to four transmitters.
8. Turn the ignition switch to the ON (one more click forward) position in order to exit the keyless entry transmitter mode.
9. Operate the transmitter functions in order to verify correct system operation.
10. [edit] Warnings Some models may require security system or other fuses to be removed.
[edit] Tips
* On some models, the first keyless entry programmed will set to Driver 1, and the second to Driver 2.
1. Access the programming connector located in the LH trunk. Trim may have to be pulled back to access programming connector.(Connector has wires leading up to it and it is not connected to anything.)
2. Jump programming connector terminals.
3. System should now lock and unlock doors to indicate programming
mode has been entered.
4. Press any button on keyless remote once.
System should now lock and unlock doors, indicating
successful programming of keyless remote.
5. Repeat step 4 for additional remote or other existing keyless remote.
NOTE: A maximum of only two Keyless Remotes can be programmed.
6. Remove programming connector jumper wire to exit programming mode.
7. Test remote(s).